Bentel Omnia 4 Especificações descarregar pdf (Página 19)

Terminal board

Below is a detailed description of the Main Unit terminal board, keypads

and key readers.

Ø The Terminal column shows the terminal number and the identifier abbre-

viation of each terminal (in square brackets).

Ø The DESCRIPTION column holds the description of the terminals.

Ø The V column shows the voltage on the corresponding terminal. The I column

shows the maximum current for each terminal. Refer to the note below the fol-

lowing table, for the meaning of the number in round brackets (1).

Main Unit

Terminal DESCRIPTION V I

5-7-8-10-11-13-14-16

[L1……L8]

Alarm Zones programmable as NC, NO, Balanced or

Double Balanced

- -

4 [--]

6-9-12-15-18 [ ]

Ground and Negative 0 -

1 [+] Power supply to control devices (keypads and key readers) 13.8 (1)

2 [C]

Connection terminal for standard BPI control devices

(keypads and key readers)

- -

3 [R]

Connection terminal for standard BPI control devices

(keypads and key readers)

- -

17 [AS] Balanced Tamper line - -

19-20-21

[NO-COM-NC]

Voltage free alarm-relay contacts

in standby status è NC connected to COM and NO open

in Alarm status è NO connected to COM and NC open

- 1

22 [+B] Auxiliary power supply 13.8 (1)

23-24

[O1] [O2]

Open-collector auxiliary output programmable for the signalling

of: Armed Partitions, Disarmed Partitions, Trouble, Alarm

Mem., Exit Time, Entry Time, Chime, Arming Delay,

Alarm/Tamper, Fire GND, Telephone Line Trouble

the output status can be either terminal to ground or

terminal open. The standby status is programmable

0 0.1

27-28 [LE] Terminals for the External Telephone Line connection - -

29-30 [LI]

Terminals for the connection of other telephone devices on

the same Control Panel line (switchboard, telephone, fax,

modem, etc.)

- -

31 [ ]

Earth - -

(1) The total current absorbed by terminals [+B] and [+] must not exceed 1 A.

INSTALLATION 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 111 112

Comentários a estes Manuais

Sem comentários

Bentel Omnia 4 Especificações Página 19

Comentários a estes Manuais